Mounting artwork on paper

This article offers general guidance and is not intended to be a substitute for the professional advice of an accredited conservator. Press the driver down on the spacers and then into the frame. It's always better to release more paper than necessary and then let it fall back into place up to the area that will need to be exposed.

The tension of the cord or wire should be checked to ensure that there is no strain on the frame when it is hanging. In a pinch, you can use a heavy-duty staple gun and some type of fastener from a hardware store.

MicroChamberTM board - MicroChamberTM technology is the trade name given to products which contain molecular sieves zeolites which 'trap' pollutants commonly found in the environment and may be generated internally within the frame package. Grafix Double Tack Mounting Film is acid free and archival.

An old frame will sometimes need to be modified to meet these criteria.

Float Mounting

Press the spacers firmly into the glass to help them stick. Pre-drilling will help prevent the frame from splitting. It is standard for prints, charcoal drawings, illustrations, and any pen and ink on paper where the artifact itself--the piece of paper--showcases the rough edge of the paper.

Unfortunately, some mounting and framing techniques not only fail to protect, but are potentially damaging to works of art. Cut eight strips of self-adhesive linen hinging tape, about two inches long. Here's my 12" x 24" Ampersand Claybord. The moulding must be both strong enough and deep enough to support the whole package.

It might be necessary to clean the glass two or three times. Once the board is perfectly centered over my artwork, I pressed down on the left side to make contact with the exposed tacking sheet.

At this point my piece measures Conservation Level For framing original works on paper Conservation mount board This refers to board made from chemically purified wood pulp and then alkaline buffered. I'm lifting the top release paper to expose part of the tacky area; this will be a section about an inch wide.

Float Mounting

Wire cutters to cut the spacers Pliers to remove frame tabs Bullfrog clips or sliding clips to hold your artwork while you secure it. Loop the wire across the back for hanging. Float Mounting Introduction Float mounting creates a seamless presentation.

Old decorative mounts such as Victorian gilt mounts can sometimes be re-used with an internal lining. Unfortunately, some mounting and framing techniques not only fail to protect, but are potentially damaging to works of art. 'Conservation framing' is a term used to describe the use of materials and techniques which provide protection to framed works of art on paper.

Mounting Systems

Next, adhere the paper to the wood surface, and cover the artwork/wood piece with a clean sheet of paper as a protective barrier.

Using your palm, press firmly over the entire surface to remove any air pockets. Mounting paper on board using Grafix Double Tack Mounting Film can be challenging at first.

This mounting film is permanent and accidents can happen, especially if one doesn't practice ahead. I've being using this method for years and I'm quite comfortable with it.

Next, adhere the paper to the wood surface, and cover the artwork/wood piece with a clean sheet of paper as a protective barrier.

Using your palm, press firmly over the entire surface to. How have standards and options for framing works on paper changed in recent years? I think the standards have always been, first, to protect the work as much as possible and, second, to make sure that anything done to the work on paper in the framing process is as reversible as possible.

Professional Custom Mounting of finished artwork. Paintings made on paper mounted on panel with the deckle edge The paintings below are by the artist Timothy McDowell.

Mounting artwork on paper
Rated 3/5 based on 89 review
Mounting Systems - Art Supplies at BLICK art materials - Art Supply Store